Push back on the t-post away from the pounder, then push the top of the pounder so the rim sets beneath the lowest knob possible on the t-post. It should be on the side of the post with the knobs. To do so, put the closed end of the post pounder on the ground about 6 inches from the t-post. The post pounder can also be used to remove t-posts. The tool is difficult to use on slanting posts. It is not suitable for posts which will be shorter than the length of the tool, or for posts which do not fit easily into the tube because of bulges or curves, or their over-large diameter. Because the tube guides the striking force consistently in line with the post and strikes it across its full width, a post pounder usually damages the top of the post less than a maul. Unlike a maul it can be used easily on tall posts, such as those used for deer fencing. The closed end strikes the top of the post, driving it into the ground. The open end is put over the top of the post to be driven, then the tool is lifted and dropped repeatedly onto the top of the post. An early type was developed in 1933 by the Pennsylvania Department of Transportation to aid the installation of fencing along roads and highways.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |